Overview

This guide walks you through the installation process for your weather shields, along with useful tips to help you get the best fit and finish.


  • Installation Tips – Weather Shields

    • Clean the surface thoroughly before installation
      Ensure the window frame is free from dust, wax, and grease so the adhesive bonds properly. Use alcohol wipes or a suitable cleaner such as isopropyl alcohol (IPA) or methylated spirits.
    • Dry fit before removing tape backing
      Position the weather shield first to confirm correct alignment. Check both front and rear pieces. Once the 3M adhesive sticks, it cannot be repositioned.
    • Install in a warm, dry environment
      Adhesive performs best in mild temperatures and dry conditions. A heat gun or hair dryer can be used lightly to improve adhesion — avoid overheating the shields.
    • Apply firm, even pressure after fitting
      Press along the entire length to ensure proper bonding.
    • Allow curing time (24–48 hours)
      Do not roll the windows down immediately after installation to allow the adhesive to fully cure.

Videos Demo


 






DONT's

  • Don’t install on a dirty or wet surface
    This will weaken the adhesive and cause lifting.
  • Don’t rush the alignment
    Misalignment can cause wind noise or poor fitment.
  • Don’t stretch or force the weather shield into place
    This can damage the product and affect adhesion.
  • Don’t roll windows down immediately after fitting
    This can dislodge the adhesive before it fully bonds.
  • Don’t install in extreme cold or wet weather
    Poor conditions reduce adhesive effectiveness.